HappyModel BNF Moblite7 HDZERO 1S 75mm Whoop - Choose Your RX

  • VendorRaceDayQuads

Description

The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and a built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver.  With powerful EX1002 KV20000 motors and a Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.

UART ELRS v3.0 ready

Be sure to check out all our pre-built quads, and all our Happymodel products

Features

  • The lightest 1S 75mm brushless whoop
  • Powerful and efficiency
  • The lightest 1S AIO 5IN1 F4 flight controller
  • 1002 brushless motors
  • Low-profile Canopy design
  • HD Zero

Specifications

  • Wheelbase: 75mm
  • Size: 97x97x25mm
  • Weight: 19.5g (without battery)
  • Weight: 36g

Motor

  • Model: EX EX1002 20000KV
  • Configuration: 9N12P
  • Stator Diameter: 10mm
  • Stator Length: 2mm
  • Shaft Diameter:Φ1.5mm
  • Motor Dimension(Dia.Len): Φ13.5mmx12.5mm
  • Weight(g): 2.5
  • No.of Cells(Lipo): 1S only

Flight Controller

  • SPI ELRS version Firmware target: CrazybeeF4SX1280
  • SPI FRSKY version Firmware target: CrazybeeF4FR
  • MCU: STM32F411CEU6 (100MHz, 512K FLASH)
  • Sensor: ICM20689 or ICM42688P or BMI270(SPI connection)
  • Original whoop size compatible
  • Power supply: 1S battery input (DC 2.9V-4.35V)
  • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
  • Built-in Betaflight OSD(SPI Control)
  • Built-in 5.8G VTX
  • Built-in SPI Frsky/ELRSreceiver
  • Built-in 5V 1A BEC
  • Built-in voltage detection
Onboard 4in1 ESC
  • MCU Upgraded to EFM8BB21
  • Power Supply: 1S LiPo/LiPo HV
  • Current: 5A continuous, peak 6A (3 seconds)
  • Support BLHeliSuite programmable
  • Factory Firmware: O_H_50_REV16_8.HEX
  • Default Protocol: DSHOT600

Onboard Frsky SPI D8 receiver Version

  • SPI BUS receiver Frsky D8/D16 compatible
  • Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
  • Channels: 8ch or 16ch
  • Failsafe support
  • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
  • Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol

Onboard ELRS Receiver Version

  • Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
  • RF Frequency: 2.4GHz
  • Telemetry output Power: <12dBm
  • Receiver protocol:  SPI ExpressLRS
  • Could bind with ELRS V2.0 firmware TX module

Onboard 5.8G 40CH 25-200mW VTX

  • Output Power: 25mw~200mw switchable
  • Frequency: 40CH
  • Input Voltage: 3.3V 5.5V
  • Current Consumption: 300mA (type)
  • Frequency: 5.8GHz 5bands 40 channels (include Race band)
  • Smart-audio Ready

HDZERO NANO LITE CAMERA SPECIFICATIONS:

  • Dimensions: 14x16x11 mm
  • Weight: 1.5gram
  • Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMOS sensor
  • Excellent low light performance
  • FOV:
    4:3: D:130° H:108° v:84°
    16:9:D:122° H:108° V:65°

    Includes

    • 1 x HappyModel BNF Moblite7 HDZERO 1S 75MM Brushless HD Whoop
    • 1 x Moblite7 Spare Canopy
    • 1 x Gemfan 1610 propeller Set (4cw+4ccw)
    • 1 x Propeller disassemble tool
    • 1 x Screwdriver

     

    Product form

    $198.99

      SKU: sku-40049352999025

      Brand: RaceDayQuads | Quad

      Product Tags

      Description

      The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and a built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver.  With powerful EX1002 KV20000 motors and a Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.

      UART ELRS v3.0 ready

      Be sure to check out all our pre-built quads, and all our Happymodel products

      Features

      • The lightest 1S 75mm brushless whoop
      • Powerful and efficiency
      • The lightest 1S AIO 5IN1 F4 flight controller
      • 1002 brushless motors
      • Low-profile Canopy design
      • HD Zero

      Specifications

      • Wheelbase: 75mm
      • Size: 97x97x25mm
      • Weight: 19.5g (without battery)
      • Weight: 36g

      Motor

      • Model: EX EX1002 20000KV
      • Configuration: 9N12P
      • Stator Diameter: 10mm
      • Stator Length: 2mm
      • Shaft Diameter:Φ1.5mm
      • Motor Dimension(Dia.Len): Φ13.5mmx12.5mm
      • Weight(g): 2.5
      • No.of Cells(Lipo): 1S only

      Flight Controller

      • SPI ELRS version Firmware target: CrazybeeF4SX1280
      • SPI FRSKY version Firmware target: CrazybeeF4FR
      • MCU: STM32F411CEU6 (100MHz, 512K FLASH)
      • Sensor: ICM20689 or ICM42688P or BMI270(SPI connection)
      • Original whoop size compatible
      • Power supply: 1S battery input (DC 2.9V-4.35V)
      • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
      • Built-in Betaflight OSD(SPI Control)
      • Built-in 5.8G VTX
      • Built-in SPI Frsky/ELRSreceiver
      • Built-in 5V 1A BEC
      • Built-in voltage detection
      Onboard 4in1 ESC
      • MCU Upgraded to EFM8BB21
      • Power Supply: 1S LiPo/LiPo HV
      • Current: 5A continuous, peak 6A (3 seconds)
      • Support BLHeliSuite programmable
      • Factory Firmware: O_H_50_REV16_8.HEX
      • Default Protocol: DSHOT600

      Onboard Frsky SPI D8 receiver Version

      • SPI BUS receiver Frsky D8/D16 compatible
      • Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
      • Channels: 8ch or 16ch
      • Failsafe support
      • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
      • Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol

      Onboard ELRS Receiver Version

      • Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
      • RF Frequency: 2.4GHz
      • Telemetry output Power: <12dBm
      • Receiver protocol:  SPI ExpressLRS
      • Could bind with ELRS V2.0 firmware TX module

      Onboard 5.8G 40CH 25-200mW VTX

      • Output Power: 25mw~200mw switchable
      • Frequency: 40CH
      • Input Voltage: 3.3V 5.5V
      • Current Consumption: 300mA (type)
      • Frequency: 5.8GHz 5bands 40 channels (include Race band)
      • Smart-audio Ready

      HDZERO NANO LITE CAMERA SPECIFICATIONS:

      • Dimensions: 14x16x11 mm
      • Weight: 1.5gram
      • Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMOS sensor
      • Excellent low light performance
      • FOV:
        4:3: D:130° H:108° v:84°
        16:9:D:122° H:108° V:65°

        Includes

        • 1 x HappyModel BNF Moblite7 HDZERO 1S 75MM Brushless HD Whoop
        • 1 x Moblite7 Spare Canopy
        • 1 x Gemfan 1610 propeller Set (4cw+4ccw)
        • 1 x Propeller disassemble tool
        • 1 x Screwdriver

         

        Recently viewed products

        © 2024 Caloosa Trains And Hobbies,

          Login

          Forgot your password?

          Don't have an account yet?
          Create account