TRA8946, Traxxas Maxx Steering Bellcranks
This is a replacement pack of Traxxas Maxx Steering Bellcranks, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
Includes:
(2) Steering Bellcranks
(1) Bellcrank support
(1) Servo saver
(1) Servo saver spring
(1) Draglink
(2) 3x20mm shoulder screws
This product was added to our catalog on May 7, 2021
TRA8948X, Traxxas Maxx Aluminum Front Toe Link
This is an optional set of Traxxas Maxx Aluminum Front Toe Links, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck. These parts are anodized blue and machined from quality 7075-T6 aluminum to be stronger than titanium and stock parts.Includes:
(2) Rod ends, rear
(4) Rod ends, front
(1) Aluminum wrench
This product was added to our catalog on September 7, 2021
TRA8950, Traxxas Maxx Driveshaft Assembly
This is a replacement Traxxas Maxx Driveshaft Assembly, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
Includes:
(1) Driveshaft assembly Maxx® Duty (front or rear)
(1) Screw pin
This product was added to our catalog on April 18, 2021
TRA8950X, Traxxas Maxx Steel Constant-Velocity Driveshaft Set (4)
The Traxxas Maxx Steel Constant-Velocity Driveshaft Set is a heavy duty upgrade for your Traxxas Maxx. Package includes the parts needed to replace all four driveshafts, as well as bearings and hardware.
NOTE: TRA7758 wheel nuts and TRA8654 wheel hubs are required for completion.
This product was added to our catalog on May 7, 2021
TRA8951, Traxxas Maxx 4x15.8mm Drive Cup & Screw Pin
This is a replacement Traxxas Maxx 4x15.8mm Drive Cup & Screw Pin, intended for use with the Maxx 1/10 Brushless Monster Truck. Use only with TRA8950X, TRA8950A driveshafts.
This product was added to our catalog on September 7, 2021
TRA8952, Traxxas Maxx Hub Carriers
Carriers, stub axle (left & right)Left and right stub axle carriers
This product was added to our catalog on September 7, 2021
TRA8954, Traxxas Maxx Front Drive Hub w/3x10mm Screw Pin
This is a replacement Traxxas Maxx Front Drive Hub with a 3x10mm Screw Pin, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
This product was added to our catalog on September 7, 2021
TRA8956, Traxxas Maxx Wheel Hex (2)
This is a replacement set of two Traxxas Maxx Wheel Hexes, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
Includes:
(2) Wheel hex
(2) 2.5x12 pins
This product was added to our catalog on May 7, 2021
TRA8957, Traxxas Maxx Wheel Washers (Black) (4)
This is an optional pack of four Traxxas Maxx Wheel Washers, intended for use with the Maxx 1/10 Brushless RTR 4WD Monster Truck. These washers are available in multiple colors to match your build.
This product was added to our catalog on September 7, 2021
TRA8957G, Traxxas Maxx Wheel Washers (Green) (4)
This is an optional pack of four Traxxas Green Maxx Wheel Washers, intended for use with the Maxx 1/10 4WD Monster Truck.
This product was added to our catalog on September 7, 2021
TRA8957T, Traxxas Maxx Wheel Washers (Orange) (4)
This is an optional pack of four Traxxas Maxx Wheel Washers, intended for use with the Maxx 1/10 Brushless RTR 4WD Monster Truck. These washers are available in multiple colors to match your build.
This product was added to our catalog on September 7, 2021
TRA8957X, Traxxas Maxx Wheel Washers (Blue) (4)
This is an optional pack of four Traxxas Blue Maxx Wheel Washers, intended for use with the Maxx 1/10 4WD Monster Truck.
This product was added to our catalog on September 7, 2021
TRA8958, Traxxas Rod Ends w/Steel Pivot Balls (Assembled)
Traxxas Rod Ends with Steel Pivot Balls. These rod ends are intended for use with the Traxxas Maxx Equipped with TRA8547, TRA8948 or TRA8997. Package includes four optional rod ends.
This product was added to our catalog on September 7, 2021
TRA8959, Traxxas Springs Shock Natural Gt-Maxx 2.054 Rate
GT-Maxx® shock springs are offered in different rates to tune your Maxx's® suspension performance or compensate for lighter or heavier vehicle configurations. The higher the spring rate number, the firmer the spring. (2.054 rate) (1 pair)
This product was added to our catalog on April 19, 2021
TRA8960, Traxxas Maxx Motor Mounts
Motor mounts (front and rear)/ 4x10 BCS with split and flat washers (1)/ pin (1)
Blue aluminum front and rear motor mount with 4x10 mm screw, washers, and pin
This product was added to our catalog on September 7, 2021
TRA8972, Traxxas Maxx 2.8" All-Terrain Pre-Mounted Tires (2) (Black)
Traxxas Maxx 2.8" All-Terrain Pre-Mounted Tires. Package includes two replacement "TSM rated" tires, pre-mounted on black 17mm splined wheels.
This product was added to our catalog on May 7, 2021
TRA8977, Traxxas Maxx Rear Ring & Pinion Gear
This is a replacement Traxxas Maxx Rear Ring and Pinion Gear, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
This product was added to our catalog on September 7, 2021
TRA8982, Traxxas Maxx Differential Gear Set
This is a replacement Traxxas Maxx Diff Gears Set, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck.
Includes:
(2) Output gears
(4) Spider gears
(2) Spider ger shafts
(2) Output shafts
(2) 2.5X13.8 pins
This product was added to our catalog on June 5, 2021
TRA8987, Traxxas Maxx Gear Covers
This is a replacement set of two Traxxas Maxx Gear Covers, intended for use with the Maxx 1/10 Brushless Monster Truck.
This product was added to our catalog on September 7, 2021
TRA8988, Traxxas Maxx Gear Center Differential (44T)
mod 1 (1.0 metric pitch) 44-tooth metal center differential gear
This product was added to our catalog on September 7, 2021
TRA8990, Traxxas Maxx LED Light Kit
This is the Traxxas Maxx LED Light Kit, intended for use with the Maxx 1/10 Brushless 4WD Monster Truck. When Traxxas developed the Maxx they knew they would need to create a light kit capable of matching its rugged off-road capabilities. Built to handle brutal real-world punishment, this light kit is waterproof and built tough for maximum fun. The bright white LEDS will light up the night trails and keep you bashing when the sun goes down.
The included high voltage amplifier packs the muscle to efficiently power the high-power light bar, while minimizing losses from excessive current and heat. The tightly regulated output provides stable lighting performance, without flickering or dimming as the battery voltage changes. The smart brake lights work when brakes are applied in both forward and reverse directions. This eliminates the common and annoying problem with generic aftermarket systems that turn on the brake lights while reversing.
Wiring is simple: Plug the main connector from the power amplifier into the power port on the Traxxas VXL-4s Electronic Speed Control, and then plug the individual lighting modules into the power amplifier. Switch between three manual lighting modes on the power amplifier (such as high beam and low beam), or use the Traxxas Link app and Wireless Module (TRA6511) to control individual lights remotely and create custom lighting configurations.
Features:
Compatible with Velineon VXL-4s ESC
Fully functioning brake lights that work
in both forward and reverse direction
Fully waterproof
Three default lighting modes controlled from the power amplifier
Low and high beam brightness settings
Easy to install with simplified, concealed, color-coded wiring
Includes front and rear bumpers with LED cutouts
Firmware updatable through the app
App-controlled lighting functions:
Turn lights on/off remotely
Build a custom dashboard
Customize lighting configurations and actions
Add additional lighting components
Includes:
High-output front LED light bar
Multi-function rear LED light bar
Replacement bumpers with LED cutouts
High-voltage 8-channel power amplifier for intense, brilliant LED lighting
Regulated output for stable lighting performance
(no flickering or dimming as the battery voltage changes)
Mounting hardware
This product was added to our catalog on May 5, 2021
TRA8991, Differential, front, complete (fits Maxx®)
The Pro Built® front differential comes completely assembled and ready to install in your Maxx®. Includes differential pinion gear and bearings.
This product was added to our catalog on June 5, 2021
TRA8992, Traxxas Maxx Complete Rear Differential Assembly
The Pro Built® rear differential comes completely assembled and ready to install in your Maxx®. Includes differential pinion gear and bearings.
This product was added to our catalog on June 5, 2021
TRA8993, Half shaft set, left or right (plastic parts only) (internal splined half shaft/external splined half shaft) (4 assemblies) (for use with #8995 WideMaxx™ suspension kit)
This product was added to our catalog on May 7, 2021
8995 - Suspension kit, WideMaxx™, black (includes front & rear suspension arms, front toe links, outer half shafts (extended), rear shock springs)
TRA8995, SUSPENSION KIT WIDEMAXX BLK
This product was added to our catalog on September 7, 2021
TRA8995G, Traxxas Maxx WideMaxx Suspension Kit (Green)
The Traxxas WideMaxx Suspension Kit is a suspension upgrade that adds 40mm to the track width (20mm per side), and includes extreme-duty cold-weather suspension arms, offering increased performance and durability. Updated springs are included to use in the rear of the truck, while the original rear springs get moved up to the front for optimized balance. Additionally, a set of wider toe links for the front and extended outer half shafts are included for all four wheels to finish off the widened stance. Plus, the kit is available in multiple colors allowing you to add a custom look to your Traxxas Maxx.
Installation is simple, thanks to the Maxx’s thoughtful engineering throughout which makes removal and replacement of the included components quick and easy. The option to utilize existing components including the stock axles saves time and gets you driving even faster.
Features:
Widens the Maxx by 1.57” (40 mm) for increased cornering stability
Extended arms constructed from extreme-duty cold weather compound
Increases cornering stability
Includes 1.725 Rate rear springs
Includes:
(4) Upper suspension arms
(4) Lower suspension arms
(4) Extended outer half shafts
(2) WideMaxx toe links
(2) Rear springs (1.725 rate)
This product was added to our catalog on May 27, 2021
Traxxas Machined Mod 1.0 Pinion Gear w/5mm Bore
Traxxas Machined Mod 1.0 Pinion Gear with 5mm Bore. This is an optional machined pinion gear intended for the Traxxas E-Revo 2.0 and the Traxxas Maxx.
The gear is available in a variety of tooth count options, please select the specific gear you want. Package includes one pinion gear.
NOTE: For use with steel spur gears.
This product was added to our catalog on April 12, 2021
Traxxas Steel Wide-Face Mod 1.0 Spur Gear
This is an optional Traxxas Steel Wide-Face 1.0 Metric Spur Gear, intended for use with the Maxx 1/10 Brushless Monster Truck and the X-Maxx 8S 4WD Brushless Monster Truck.
This spur is available in multiple tooth count options.
Fits:
Traxxas Maxx
Traxxas X-Maxx
Traxxas XRT
This product was added to our catalog on May 7, 2021
YEA-TRMA-002, Yeah Racing Traxxas Maxx 4S HD Steel Front/Rear Universal Drive Shafts (2)
Yeah Racing Traxxas Maxx 4S HD Steel Front/Rear Universal Drive Shafts. These optional drive shafts are great for increasing the strength of the front or rear of the Traxxas Maxx 4S. Package includes two assembled driveshafts.
NOTE: It is always recommended to use a small amount of blue thread locker on the drive shaft set screws.
Features:
Perfect fit for the Traxxas Maxx 4S
Made from steel to increase the strength
This product was added to our catalog on May 18, 2021
