Leopard 56110 brushless motorSpecial while supplies last, includes water Jacket with Leopard Motor Purchase!56mm Diameter x 110mm Long Brushless Motor by Leopard Power. Hand wound for high efficiency of up to 90%.Comes with high quality bearings and neodymium magnets for high power. Includes endbells that are assembled with screws for both strength and ease of maintenance.Specs:Magnets: NeodymiumWatts: 5000 with Over 6000 Burst.Poles: 4Motor Shaft: 8mmCan Measures: 56mm diameter x 110mm longMounting screw diameter required: 4mmMounting Holes 30mm apartWeighs: 40.5 ouncesBearing size: 8mm wide x 19mm od x 6mm idIncludes Leopard 6.0mm male bullet plugs soldered to the motor and a matching set for your esc connection.
OSE Suggests 20,000-35,000 total rpm for boats. We suggest most Fast Electric Boaters should run in the 25,000RPM range for Sport Boating or 30,000RPM Range for racing. These are only guidelines, we suggest if you do not have the knowledge to pick the correct motor, please consult us first or other members of the rc fast electric boating community. Either at a local club or on our OSE Forums.
TFL's new Bearing Clamp Oiler. Just tighten and attach an oil source and you will have easy and convenient lubrication during run time. Specs:- For .250" 6.35mm Cables- Bearing Diameter: 6.85mm- Water Fitting: M5- Length: 20mm (0.79")- Width: 30mm (1.18")- Height: 30mm (1.18")- Weight: 19.84g (0.7 Oz)
Aluminum with anodized silver servo mount for standard size servos(for example Futaba S3003 etc.).Servo width mounting plate is adjustable.All nuts and screws included. Servo NOT included.
Notes: For use in a rc boat this will require either gluing it directly to the hull or a wooden base to screw into. Some servos will require slight modifications if there are bulges or wires sticking out of the sides.Will fit upto 43mm wide servo.
CNC cut aluminum mount works well in narrow areas like catamaran sponsons where there isn't enough room for an adjustable mount. The fixed angle is ridged enough for the longest of 56mm motors. Shown in picture with Leopard 5692 (not included) and Ham-leopard-56L water jacket (not included).Specifications:Motor holes are 30mm apart.Holes for 4mm screws.67mm (2.64") wide.Weight 3.4 ounces Available in Black or Silver Colorations
Requires:Installation, Glue and fiberglass to fix the mount into the hull. Motor mounting screws.
SPDSD-6090: Nitro, for 1/4" (.250") propeller shaft.
Speedmaster Stinger StrutIt can be quickly adjusted from positive to negative thrust angles. The bushing is cross drilled to hold grease for an extra smooth driveline. It is constructed with high quality aluminum and CNC cut to tight tolerances. This has been often copied by other manufactures but never truly has been duplicated.
SPDT-150, Speedmaster 1.5" x 1.5" Adjustable Metal Trim Tabs (2 Pairs)
Speedmaster 1 1/2" x 1 1/2" tabs. These tabs are perfect for dialing in any mono and at the same time saving some weight. CNC cut Aluminum adjusting bracket with stainless trim plate.Same as part number ros-spdt-150 but this package comes with (2) pairs of tabs.These adjustable trim tabs measure approx. 1.5" (38.10mm) wide x 1.5" (38.10mm) Long x .70" (17.80mm) height(2) pairs per pack.
