ECP-5118, EcoPower "Basher" 3S 60C Hard Case LiPo Battery w/EC5 (11.1V/5000mAh)
This EcoPower 3S Hard Case LiPo Battery is your go-to option when it's time pull the trigger wide open, light up the tires and fling some dirt!
Sized for Arrma, Losi and more, this battery features a hard plastic exo-skin that protects the inner cells from the abuse of bashing. The case also features wire slots designed to allow the leads to sit flat, in the event you stack two batteries together for 6S use.
For Arrma vehicles that use the long inboard hook & look strap, you'll find the balance lead and ESC wires spaced apart to allow that strap to secure the batteries without damaging the wires.
Features:
Hard plastic case
Stackable design
60C discharge rate
5000mAh of capacity
EC5 connector (compatible with IC5)
Also available as a 4S (ECP-5119)
Specifications:
Type: Lithium Polymer
Capacity: 5000mAh
Voltage: 11.1V nominal
Connector Type: EC5 Ultra (12GA Wire)
Balancer Type: Align/E-Flite compatible (XH)
Number of Cells: 3
Weight: 365g
Dimensions (WxLxH): 47x139x37mm
Maximum Charge Rate: 2C (8.2A)
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell) Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.
This product was added to our catalog on December 16, 2021
ECP-5119, EcoPower "Basher" 4S 100C Hard Case LiPo Battery w/EC5 (14.8V/5000mAh)
This EcoPower 4S Hard Case LiPo Battery is your go-to option when it's time pull the trigger wide open, light up the tires and fling some dirt!
Sized for Arrma, Losi and more, this battery features a hard plastic exo-skin that protects the inner cells from the abuse of bashing. The case also features wire slots designed to allow the leads to sit flat, in the event you stack two batteries together for 8S use.
For Arrma vehicles that use the long inboard hook & look strap, you'll find the balance lead and ESC wires spaced apart to allow that strap to secure the batteries without damaging the wires.
Features:
Hard plastic case
Stackable design
100C discharge rate
5000mAh of capacity
EC5 connector (compatible with IC5)
Also available as a 3S (ECP-5118)
Specifications:
Type: Lithium Polymer
Capacity: 5000mAh
Voltage: 14.8V nominal
Connector Type: EC5 Ultra (12GA Wire)
Balancer Type: Align/E-Flite compatible (XH)
Number of Cells: 4
Weight: 420g
Dimensions (WxLxH): 47x139x37mm
Maximum Charge Rate: 2C (8.2A)
NOTE: When using high energy Li-Polymer Batteries, please do not over-discharge or over-charge batteries as this will result in over heated batteries. Discharging capacity can't exceed 80% of the max capacity of the pack after full charging to ensure a good cycle performance. It is recommended to fully charge a brand new battery before using and only discharge the battery 50% for first 5 cycles. Always monitor race time and/or set a low voltage warning on ESC (End voltage cannot be lower than 3.2v per cell) Do not use the battery that has too low a voltage.
Do not expose batteries to sunshine or store/charge batteries at the temperature above 35°C or in a closed car. The high temperature environment could cause damage to the pack or make it burst. If the battery becomes hot while fast charging, high current discharging or racing, do not charge the battery until it has cooled completely. Wait about 20 mins, then inspect prior to recharging.
This product was added to our catalog on December 16, 2021
ECP-827, EcoPower 827 12g Digital Metal Gear Micro Servo (High Voltage)
The EcoPower 827 12g Digital Metal Gear Micro Servo is an affordable, high voltage "mighty micro" upgrade. This servo is a great choice for the Dig/Shift servo in the Axial SCX10 III, as well as a Dig servo in the Axial Capra. The servo saver adapter is included! Plus, true high voltage compatibility means no more complicated wiring to protect your accessory servos when running a high voltage steering servo.
The 827 can also be used as a steering servo upgrade for the Axial SCX24 when combined with the optional Samix Mount (SAMSCX24-6068E-BK), or Hot Racing Servo Mount (HRASXTF24M01). The 827 holds 15% more torque than other optional SCX24 servo upgrades on the market and is the first to offer high voltage for under $15.
The EcoPower 827 fits a wide range of micro servo applications, including the Losi Mini-T 2.0 and Mini-B, Axial 1/18 Yeti Jr, a multitude of aircraft and many others. The servo features a durable metal gear train, digital circuitry for increased efficiency and reliability, servo saver adapter and servo horns.
Features:
High Voltage Micro Servo
Upgrade for SCX10 III Dig and Shift Servo (direct replacement for SX107 servo - SPMSSX107)
Upgrade for Capra Dig Servo
Upgrade for SCX24 Steering Servo (requires Hot Racing or Samix Servo Mount)
Includes Servo Saver Output Adapter for SCX10 III and Capra
Metal Gears
275mm Servo Lead
Specifications:
Operating Voltage: 6.0V to 8.4V
Operating Speed:
@6.0V: 0.12 sec/60
@8.4V: 0.10 sec/60
Torque:
@6.0V: 29.1oz-in (2.1kg-cm)
@8.4V: 37.5oz-in (2.7kg-cm)
Weight: 12g
Gears: Metal
Spline: 20T
Motor Type: Cored DC
Application: Small Scale Surface & Air
Includes:
EcoPower 827 Servo
Molded adaptor for Axial Servo Saver Horn w/12mm flat head screw
Molded servo horns w/M2.5 Mounting Screw
NOTE: Installation photo shows black servo horn which was achieved with Tamiya TS-6 Matte Black plastics paint (TAM85006); servo horn comes white.
This product was added to our catalog on December 16, 2021
